Extron electronics eLink 100 User Manual page 22

4. Remove the template from the wall.
NOTE: Wall anchors may be required depending on wall material and stud
locations.
5. Insert two screws (see figure 13 for screw sizes) into the mounting holes
and tighten them until the screw heads protrude from the wall at the
following distances:
Transmitter: approximately 3/16 inch (4.7 mm)
•
Receiver: approximately 1/4 inch (6.35 mm)
•
NOTE: If necessary, adjust the screw protrusion so that the
eLink 100 unit is firmly secured on the wall or furniture surface.
Rx Tx
# 8 # 10
(4 mm) (5 mm)
Pan Head
Wood Screw
Figure 13. Screw Sizes for the eLink 100 Transmitter (Tx) and Receiver (Rx)
NOTE: Choice of screw length depends on wall or furniture thickness.
6. Align the mounting holes on the back panel of the unit with the two screws protruding
from the wall (see figure 14).
Transmitter
Figure 14. Mounting the eLink 100 Units
7. Slide the unit downward until both screws are seated in the narrow parts of the two
keyholes.
eLink 100 HDMI Transmitter and Receiver • Reference Information
Receiver
16