Mastercook KG-1514ZSB DYN Instruction Manual page 33

• In the warranty period all repairs except for the
ones specified below should be carried out by the
authorised Servicing Point.
Problem
Igniters fail to ignite or not always ignite
the gas
12.1.1
Gas burners fail to ignite
Flame dies after releasing the knob
While igniting one of the burners all the
hob burner igniters spark
After setting the knob to simmering fla-
me position - the flame dies or is too
high
Flame is unstable
Damaged power lead
Cooking results are not what you expec-
ted
– Check to make sure the cooker is connected to the electrical mains.
– Clean and dry the igniters and burner components.
– Check to make sure the burner caps and heads are placed correctly.
– Press on the burner cap and rub it against the head by turning right
and left (fig. 12.1.1).
– Rub the igniter electrode with the use of hard brush or smooth file (fig.
12.1.2).
12.1.2
– Check to make sure the rubber hose supplying gas from the gas cylin-
der is not squeezed.
– Check to make sure the gas main valve is open.
– Check to make sure the gas cylinder is not empty.
– In case a new cooker has been installed or the gas cylinder has been
replaced with a new one, then it is necessary to repeat the ignition
procedure until the gas reaches the burner.
– Check to make sure the nozzle or burner flame holes are not clogged
or flooded. If so, un-clog the nozzle hole using a pin or needle. Clean
the burner flame holes with the use of brush, and then dry all compo-
nents.
Your cooker is equipped with a flame failure safety device
– Where the ignition device is activated by the button, set the knob to
large flame
button and when the gas has ignited keep the knob pressed all the
way in for another few seconds.
It is normal
When pressing the selected knob (with a built-in ignition device) or the
ignition button sparks are re-leased at all the burners .
– Avoid draughts in the kitchen,
– Call the fitter to adjust simmering flame position
– Check to make sure that the burner components are clean, dry and
placed correctly.
In order to avoid hazards, damaged power lead should be exchan-
ged at the manufacturer's or by a specialist servicing point, or by a
qualified person.
The cooking parameters given in the instruction manual should be
treated as guidance only. In practice, these parameters are depen-
dable on the weight and consistency of food, cooking tray level, etc.
Therefore, we recommend making a few trials for your favourite fo-
ods and then writing down the optimal time and temperature.
• If there are some disturbances during the use of
the appliance, follow the guidelines below to check
if you can repair the defect yourself.
Solution
and keep it pressed all the way in, press the ignition
32
EN
.