3.1 Starting the PBX
3.1 Starting the PBX
CAUTION
•
Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing
an earthing strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data will be cleared.
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the main board before startup.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".
1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
RUN Indicator
ALARM Indicator
2.
Plug the DC connector of the AC adaptor into DC IN 1.
DC Connector
AC Adaptor
20
Getting Started
DC IN 1
1
System Initialise Switch
2