Panasonic KX-TDA30 Getting Started page 28

4.3 Programming the PBX
Assigning the Incoming Trunk Call Destination
28 Getting Started
5. a.
Under Configuration, click Slot.
b.
Move the mouse pointer over the BRI card, then click
INS to set the card to in-service status.
For analogue trunk users (DIL Setting):
1. Under CO & Incoming Call, click DIL Table & Port Set-
tings.
2. Confirm that the DIL tab is selected.
3. Configure the settings as required.
4. Click OK.
For ISDN trunk users (DDI Setting):
1. Under CO & Incoming Call, click DDI / DID Table.
2. Configure the settings as required.
3. Click OK.
For ISDN trunk users (MSN Setting):
1. Under CO & Incoming Call, click DIL Table & Port Set-
tings.
2. Click the DDI / DID / TIE / MSN tab.
3. Set the Distribution Method of the desired ports to
MSN.
4. Click OK.