Pppoe - D-Link DIR-890L User Manual

Section 3 - Configuration
Select PPPoE (Point-to-Point-Tunneling Protocol) if your Internet connection requires you to enter a username and password. This information can
be provided by your Internet service provider (ISP). Required fields will vary, depending on the options you have enabled.*
PPPoE Session: Choose Share with IPv4 to re-use your IPv4 PPPoE username and
password, or Create a new session.
If you selected Create a new session above, enter the PPPoE
Username:
Username provided by your ISP.
Password: If you selected Create a new session above, enter the PPPoE
Password provided by your ISP.
Select Static IP if your ISP assigned you the IP address, subnet mask,
Address Mode:
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP Address provided by your ISP (for Static IP only).
Service Name: If you selected Create a new session above, enter the ISP Service
Name (optional).
If you selected Create a new session above, select either Always
Reconnect
Mode: on, On demand, or Manual.
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Select either Obtain DNS server address or Use the following DNS .
DNS Type:
If you selected Use the following DNS, enter the Primary DNS
Primary DNS
Server: Server address.
Secondary DNS If you selected Use the following DNS, enter the Secondary DNS
Server address.
Server:
Note: When you select Share with IPv4 and Dynamic IP instead of Create a new session and Static IP, less fields are required. See screen shot on the next page.
D-Link DIR-890L User Manual

PPPoE

43