L2Tp - D-Link DIR-890L User Manual

Section 3 - Configuration
Choose L2TP (Layer 2 Tunneling Protocol) if your Internet Service Provider (ISP) uses a L2TP connection. Your ISP can provide you with a username
and password.
L2TP Server IP Address: Enter the L2TP Server IP Address provided by your ISP.
Username: Enter the Username provided by your ISP.
Password: Enter the Password provided by your ISP.
Reconnect Mode: Select either Always on, On demand, or Manual.
Maximum Idle Time: Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature, enable
Auto-reconnect.
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases, select
Dynamic IP.
L2TP IP Address: Enter the L2TP IP Address provided by your ISP (for Static IP only).
L2TP Subnet Mask: Enter the L2TP Subnet Mask provided by your ISP (for Static IP
only).
L2TP Gateway IP Enter the L2TP Gateway IP Address provided by your ISP (for
Address:
Static IP only).
Enter the Primary DNS Server IP address assigned by your ISP.
Primary DNS Server:
Secondary DNS Server: Enter the Secondary DNS Server IP address assigned by your ISP.
MTU: Maximum Transmission Unit - by default this field will be set to
Auto. Select Manual if you need to change the MTU for optimal
performance with your ISP.
Click Save when you are done.
D-Link DIR-890L User Manual

L2TP

36