Read And Save These Instructions; Electrical Requirements - Livestrong LS9.9T Service Manual

CHaPTer 2: important Safety instructions

2.2 read aNd SaVe THeSe iNSTrUCTiONS

To ensure your safety and protect the equipment, read all instructions
before operating the LIVESTRONG LS9.9T treadmill.
When using an electrical product, basic precautions should always be
followed including the following:
daNGer: To reduce the risk of electric shock: always unplug this
equipment from the electrical outlet immediately after using and
before cleaning.
WarNiNG: To reduce the risk of burns, fire, electrical shock or
injury to persons that may be associated with using this product.
An appliance should never be left unattended when plugged in. Unplug
from the outlet when not in use and before putting on or taking off parts.
This product must be used for its intended purpose described in this service
manual. Do not use other attachments that are not recommended by the
manufacturer. Attachments may cause injury.
To prevent electrical shock, never drop or insert any object into any open-
ing.
Never operate the treadmill with the air opening blocked. Keep the air
opening clear, free of lint and hair.
Never operate product if it has a damaged cord or plug, if it is working
improperly, if it has been damaged, or immersed in water.
Do not carry this unit by its supply cord or use the cord as a handle.
Keep any power cord away from heated surfaces.
Close supervision is necessary when the treadmill is used by or near chil-
dren or disabled persons.
Do not use outdoors.
Do not operate where aerosol (spray) products are being used or when
oxygen is being administered.
To disconnect, turn all controls to the off position, then remove plug from the
outlet.
Connect this treadmill to properly grounded outlets only.

2.3 eLeCTriCaL reqUiremeNTS

This product is for use on a nominal 110-volt circuit and has a grounding
plug that looks like the illustration below. This product must be used on a
dedicated circuit. NOTE: There are usually multiple outlets on one circuit.
This treadmill should be used with a minimum 15-amp circuit.
To determine if you are on a dedicated circuit, shut off the power to that
circuit and observe if any other devices lose power. If so, move devices to
a different circuit.
This product must be grounded. If a treadmill should malfunction or
breakdown, grounding provides a path of least resistance for electrical
current to reduce the risk of electrical shock. This product is equipped
with a cord having an equipment-grounding conductor and a grounding
plug. The plug must be plugged into an appropriate outlet that is properly
installed and grounded in accordance with local codes and ordinances.
Improper connection of the equipment-grounding conductor can result in
a risk of electric shock. Check with a qualified electrician or serviceman if
you are in doubt as to whether the product is properly grounded. Do not
modify the plug provided with the product. If it will not fit the outlet, have a
proper outlet installed by a qualified electrician.
5