Novra S300N User Manual page 29

5. Exit: Exits the S300 Console program
6. Change Firmware: Allows the user to download a new firmware load for the S300 receiver.
Before changing the firmware in your S300 receiver, you will need to change the
NOTE:
IP address of your receiver to 192.168.0.x AND change the IP address of your
configuration PC to the same subnet (192.168.0.y, where y ≠ x and y ≠ 1). After
completing the firmware upgrade, you can change your IP addresses back.
To change the S300 firmware, please refer to the figure below:
a. Select Code File and browse to the S300 code update binary file.
b. Select Commit.
c. On the firmware upload is complete you should get a message stating the Receiver
firmware has been rewritten. The S300 Console program will then shut down and
must be restarted to continue configuring the S300.
d. If you get a Code Download Failed timeout error, ensure your have changed your IP
addresses per the note above.
Version: 1.2
Figure 11 - Change Password
Confidential and Proprietary 29 of 40