Novra S300N User Manual page 11

You can now select the device you wish to configure by double clicking on the receiver model type in
the Devices Discovered listing.
If there is an S300 receiver accessible on your network, but not on your local LAN you can still
configure it as if it were on your local LAN. In the Managed List section of the screen above, enter
the IPE address of the receiver you wish to configure in the IP field. You can also provide an optional
name beside it if you wish. Once the IP address is entered, click Add to add the IP address to the
Managed List. Now double click the IP address you just added to run the Configure Application on
the receiver. You can use the Add, Delete, and Delete All buttons to add/remove entries in the
Managed List.
3- You must also ensure that the network settings of the S300 make it accessible from the Windows
management PC. The IP address of the device and the IP address of the management station must
reside on the same subnet, or there must be a route that connects both of them through a router. If
this is NOT the case, you will be prompted with the Change IP Address Screen as shown below in
– Change IP Address Screen
Figure 3
management PC to be on the same subnet as the receiver (in this case, change your PC IP address
to: 192.168.254.xxx, where xxx is not equal to 242).
4- You can also use the Managed List section of the Device List Screen (reference Figure 2 above) to
direct the S300 Console to connect to a receiver that is available on your network, but not available
on your local LAN. In this case, the auto discovery will not be able to find your receiver (since it is not
on your LAN), but you can enter the routable IP address of your S300 in the IP box shown in the
lower left hand corner of the Managed List screen. Simply click the Add button to add this IP
Version: 1.2
. You will need to change the IP address of your
Figure 3 – Change IP Address Screen
Confidential and Proprietary 11 of 40