Novra S300N User Manual page 15

ii. IP Data buttons enables the operator to configure the receiver to receive Multi-
iii. A/V Data button group (Content and PAT) provides standard and advanced
iv. Control button group provides an additional configuration item that includes
NOTE:
and re-distribute IP data, while the A/V Data function is used to configure the
to receive and re-distribute video programs. The AV Data function is not
available on your S300N receiver model.
3. The middle bar of this screen displays the IP address and MAC address for the selected
S300 being configured.
4. Status information on the operation of the S300 is provided in the lower part of the screen.
This status includes:
i. Status – Turns green when the status packets are being successfully received from
ii. Signal – Turns green when the receiver detects an input RF signal at the selected
iii. Data – Turns green when the S300 has achieved data lock. This means that the
iv. LNB – Turns green when the LNB is turned on and is gray when the LNB is turned
v. Signal Strength – Provides a graphic indication of the signal power at the input
vi. ModCod/Coding Rate : Depending on the mode of operation (DVB-S vs. DVB-
Version: 1.2
Protocol Encapsulation (MPE) data and pass/map this data onto the LAN.
features enabling the operator to receive MPEG transport stream packets and pass
these packets to Multicast IP addresses on the LAN. This functionality is not
available for the S300N and these buttons are therefore grayed out.
Reboot.
- Typically the IP Data function is used to configure the S300 to receive
the S300 by the S300 console.
frequency. This matches Signal LED on the front of unit.
receiver is able to recover all the digital timing from the input signal and is receiving a
valid DVB transport stream. This does NOT match the blue data LED on the front of
the S300.
- S300 DATA LED – The blue data LED on the front face plate of the
NOTE:
S300 will blink at a ½ second interval if data is being processed and forwarded
by the S300.
off. The LNB status LED will also turn red if there is a DC short present on the RF
connector input.
of the receiver. The signal strength is shown as both a bar graph and percentage
strength.
S2), this status value will change as follows:
Confidential and Proprietary 15 of 40