Novra S300N User Manual page 26

Referring to the figure above, the left hand side of the screen enables you to configure the mapping rules and
the right hand pane summarizes and displays the configured IP mapping rules. Up to 16 rules are supported.
The following is a description of the above screen entries:
1) Enable Mapping: Check this box to enable the mapping table. Unchecking this box can also be used
to disable the entire mapping table without losing the table contents. The table can then be re-enabled by
checking the box.
2) Original IP: The original multicast IP address that is to be mapped to a new destination IP address.
Note: This IP address must be a multicast IP address.
Version: 1.2
Figure 9 - IP Remapping
The Enable Mapping box must be
NOTE:
checked to use the IP Mapping feature
Confidential and Proprietary 26 of 40