Smart Card Reader - HP ZBook 17 G2 Maintenance And Service Manual

5. Remove the ExpressCard assembly (5) by sliding it up and to the right at an angle.
Reverse this procedure to install the ExpressCard assembly.

Smart Card reader

Description
Smart Card reader (includes cable)
Before removing the Smart Card reader, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover (see
6. Remove the optical drive (see
hard drive on page
7. Remove the keyboard (see
8. Remove the top cover (see
9. Remove the ExpressCard assembly (see
Remove the Smart Card:
1. Remove the three Phillips PM2.5×4.0 screws (1) that secure the Smart Card reader to the system board.
2. Lift the Smart Card reader slightly upward and toward the left (2).
88 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 45).
Service cover on page
Optical drive on page
58).
Keyboard on page
Top cover on page
ExpressCard assembly on page
47).
56) or upgrade bay hard drive (see
61).
71).
Spare part number
742159-001
Upgrade Bay
87).