Fastening The Power Cable; The Display; Turn On The Power - Fujitsu Primergy Econel 100 S2 Start Manual

n Fastening the power cable
To prevent the power cable from falling off when the server is pulled forward, pass the supplied release tie through
the ventilation holes on the server rear to fasten the cable. Do not fasten the cable too tightly.
When you unplug the server power cable, make sure to unplug the cable from the connector on the server.
6
Turning on the power and setting hardware
Normally, hardware settings are not required to be changed.
However, in the following cases, start up BIOS Setup Utility, and check or change hardware settings.
- When optional devices are installed
- When you want to check settings beforehand
"Chapter 7 Configuring Hardware and Utilities"
Take notes of hardware configuration and setting values of BIOS Setup Utility in the "Configuration Sheets"
that is available from Fujitsu PRIMERGY website (http://primergy.fujitsu.com).
1
Turn on the peripheral devices, such as

the display.

2

Turn on the power.

�����
�������������������������
������������������������
������������������������������
���������������������������������
������������
������������������������
�����������������������������
����������
�����������
3
Set the hardware.
If no hardware settings are performed, skip to the
next step when a message prompting you to insert
the ServerStart floppy disk is displayed.
1. When the "<F2> BIOS Setup / <F12>
Boot Menu" message appears at the server
start up (during POST), press the [F2]
key.
2. Check/change the settings.
3. Select "Save Changes & Exit" from the
Exit menu and press the [Enter] key.
4
Turn off the power of the server.
3