Yeti Cycles 303 wc 2013 Owner's Manual page 11

cable setup
yeti tips
the 303 wC has full cable housing. By using full cable housing, we have eliminated break
points in the line of your shifter housing. this allows riders to experience better overall shifting
performance by reducing the entrance of unwanted elements such as sweat and sediment.
Use of full cable housing helps prevent corrosion from the elements, damage from chain slap,
and keeps the shifting smoother for a longer period of time.
Caution: the failure to properly route shifter housing can cause malfunction of the shift mechanism and
unexpected shifting of gears.
01. rear Derailleur
Fit the housing from the rear shifter along the head tube and down the cable stops on the top of the down
tube. there are two cable stop groups on the top of the down tube to which housing and brake line can be
attached, each with two positions to secure housing. Use the position closest to the drive side of the frame
for the rear derailleur housing and secure the line with zip-ties. next route the housing internally through the
drive side seatstay. work the housing through the two holes on the drive side seatstay and loop into the rear
derailleur to finish.
22.
02. rear brake
the rear brake line loops across the head tube and runs down the cable stops on the top of the down tube.
Use zip ties to secure the line to the position closest to the non-drive side on the cable guides. next, run the
line below the shock, between the non-drive side of the swingarm and the downtube and across the single
cable guide on the bottom of the non-drive seatstay. secure the line to the guides with zip ties. ensure the
line is finished on the inside of the seatstay when attached to the caliper body. this will prevent the brake
line from being compromised if the bike or rider falls.
23.