Alarm Code, Default Codes - Videofied VISIO Installation Manual

6. Detail of the menu : ALARM
How to modify the transmission state of events?
This setting can be different from one panel to another.
It can be modified with the CODE/STATE MODIFICATION
menu.
2 possible solutions:
•
At installation, just after having validated the hour of the
cyclic test, the keypad requests :
CODE/STATE
MODIFICATION ?
•
After the initial installation, by using the keypad :
With direction arrows
CONFIGURATION (level 4) -> CONFIGURATION MONITOR.
STATION -> ALARM CODES -> TRANS. STATE
MODIFICATION
Then:
With direction arrows
transmit, make then modify the transmission state with
arrows and revalidate with the [YES] key. Renew the operation
for each event which you wish to modify the transmission
regulations.
Press on the key to access
the menu TRANS. STATE
MODIFICATION
go to the menu
Select the event to
EMEA SALES
2, rue Alexis de Tocqueville
92160 ANTONY
FRANCE
Hot line : +33 (0)820 846 620 / UK : 0871 951
Fax : +33 (0)3 90 20 66 36
© 2009 RSI VIDEO TECHNOLOGIES. VIDEOFIED
Specifications subject to change without notice.
6.2 Alarm code, default codes: (except if you are
using pre programming - Not available when the
format of FRONTEL is used)
How to modify associated alarm codes?
After having completed the installation by using the keypad :
With direction arrow
CONFIGURATION (level
MONITOR. STATION -> ALARM CODES -> ALARM CODE
MODIFICATION
Then:
With direction arrows
its associated code.
Press the key to modify the value.
Then enter the new value with the keypad and validate by
pressing the key .
Renew the operation for each device and associated code to be
modified, according to the regulations of your monitoring station.
www.videofied.com
is a Registered Trademark of RSI VIDEO TECHNOLOGIES.
TM
go to the menu
4) -> CONFIGURATION
select the device and
North American Headquarter
4455 White Bear Parkway, Suite 700
White Bear Lake, MN 55110
USA
Hot Line : 877-206-5800
Fax : 651-762-4693
9