Nexcom NDiS 161 User Manual page 37

Chapter 3: System Setup
3. Note how the module is keyed to the socket. Grasping the module
by its edges, align the module with the socket so that the "notch" in
the module aligned with the "key" on the socket. The key ensures the
module can be plugged into the socket in only one direction.
Copyright © 2008 NEXCOM International Co., Ltd. All Rights Reserved.
Key
Notch
4. Insert the module into the socket at an approximately 30 degrees
angle. Apply firm even pressure to each end of the module until it slips
down into the socket. The contact fingers on the edge of the module
will almost completely disappear inside the socket.
Push the module down. The ejector tabs at the ends of the socket
will automatically snap into the locked position to hold the module in
place.
25
NDiS 161 User Manual