Quitting-Disconnecting From The Computer; Using The Card Reader - Kodak 6B8773 User Manual

Quitting—Disconnecting from the Computer

Using the Card Reader

April 28, 2004
You may connect more than one camera or other IEEE 1394 devices to the
card as long as you avoid a closed loop configuration. (The drawing
indicates an acceptable configuration.)
The camera's IEEE 1394 port does not support a second pass-through
connector and is meant to be the last device on the "daisy chain."
You can now access your camera from the computer. See the Help for the
DCS Host Software on the DCS Host Software CD included with your camera.
Complete these steps when your work with the camera and the computer is
complete. You can connect or disconnect the camera without turning the
camera or the computer off.
NOTE: WINDOWS OS only: Do not disconnect the camera from the
computer while KODAK PROFESSIONAL DCS Camera Manager is
running. Doing so can cause your computer to "hang".
CAUTION
:
Do not disconnect the camera from the computer while
images are being transferred from the camera to the
computer. Doing so can corrupt images on the computer.
1. Quit the KODAK PROFESSSIONAL DCS Camera Manager software if is
running.
2. Disconnect the camera from the computer.
If your computer has a card reader, you can access images by placing a
memory card containing camera images in the reader. If you have a new
card reader, install it using the instructions accompanying the reader.
1. Remove the memory card from your camera.
2. Insert the memory card into the card reader on your computer.
CAUTION
:
Do not remove a card from the card reader while KODAK
PROFESSIONAL DCS Photo Desk is running. If images on the
card are open in DCS Photo Desk, removing the card can
cause you to lose data.
Connecting to Your Computer
13-3