Setting The Camera To Remote Control Mode; Cancelling Remote Control Mode - Kodak 6B8773 User Manual

Configuring your Camera
Setting the Camera to
Remote Control Mode
Cancelling Remote Control
Mode
5-28
When using the Remote Controller, use either AF or Manual focus to set the
lens focus for the scene, then switch the lens to the MF position. If the lens
is left in AF, the camera performs an autofocus when it receives the signal
from the Remote Controller and you will not be able to verify the correct
focus.
1. Press and hold the FUNC button.
The Top Status LCD shows the
2. Continue pressing the FUNC button and rotate the C-Dial to select the
channel (same channel as the Remote Controller). Release the FUNC
button.
After you set the channel, the
3. Check that the subject is framed correctly.
4. Lightly press the Shutter button to set the focus, then set the lens
switch to MF.
5. Point the transmitting diode at the camera and press the Transmit
button.
Notes:
• The Remote Controller cannot be used with Continuous Shooting mode.
If the D-Dial is set to Continuous Shooting, the camera captures only a
single image for each activation by the Remote Controller.
• The Remote Controller may not work properly if strong sunlight is
shining directly on the camera's remote control sensor.
• The camera's Meter Off time changes to a fixed five minutes when
Remote Control mode is enabled. To reactivate the camera, lightly press
the Shutter button.
• After capturing the image, repeat steps 1 and 2 (above), choosing - - to
cancel the remote control function.
mark.
mark appears on the Top Status LCD.
April 28, 2004