Rip Cage Removal - Lexmark X295 Service Manual

3.
Disconnect the cable (A) from the DC Geared motor.
4.
Remove the three screws (B) securing the paper tray lift motor to the frame.

RIP cage removal

Note: The RIP board does not need to be removed to perform this procedure.
1.
Remove the rear cover. See
2.
Disconnect all the cables from the RIP board.
3.
Remove the screw (A) securing the bottom of the RIP cage to the rear EMI shield and crossbar.
"Rear cover" on page 4-7.
7541-03x
4-95
Repair information
Previous
Next
Go Back