Geo Ensemble User Manual page 21

replace them. Make sure you use Alkaline AA
batteries (LR6). Do not use rechargeable
batteries.
Q. Why is the internet comms
symbol flashing?
A. This symbol will flash if:
• You do not have a Bridge connected to
your system.
If you do have a Bridge:
• The outer rings will flash if the Display
cannot talk to your Bridge – so try
moving them closer.
• The inner dot will flash if you do not have
a connection to the internet.
• Try checking that the ethernet cable is
connected.
Bridge
Q. How do I reset the Display (clear the data
and start again)?
A. There are two options for resetting the
Display. You can either erase the memory or
reset the network.
For either option, first unplug the Display's
power cable. Then press and hold the left and
right buttons while reinserting the power
cable.
The Display will first ask if you want to erase
the memory, 'RSR?'. Select 'Y' (left button) to
erase the memory, or 'N' (right button) to keep
the data. Next the Display will ask 'N/W?'. If
you want to unpair all connected devices
(Smart Plug, Transmitter and Bridge if you have
a Web Pack) select 'Y', or 'N' to keep them
paired. Finally the Display will ask if it should
be a Master (MST) or a Slave (SLV). Select MST
using the left button. The Display will then ask
you to reconfirm the date and time.
If you chose to reset N/W, you will have to pair
the Sensor, Bridge and Smart Plugs again, one
Router
by one.
Resetting the network is what you'll have to do
in the very rare event that two neighbouring
Ensemble systems have chosen the same
network ID.
Ensemble Electricity Monitor, User Manual page 21