Step 3 - Sensor; Step 4 - Smart Plugs - Geo Ensemble User Manual

Step 3 - Sensors
Single Phase Pack (one Sensor):
1. At your electricity meter, clip the Sensor
around a cable. You should hear a 'click'
to indicate that the Sensor has been
tightly closed.

Step 4 - Smart Plugs

1. Plug your Smart Plug(s) into any
available socket(s).
2. The button on the front of the Smart
Plug will show one of two colours:
Green: power will be provided to
the appliance.
Red: the Smart Plug is isolated and no
power will be provided to the appliance.
1
1
manual on/off
button
2. Plug the Sensor cable into the bottom of
the Transmitter.
The Display will now start to show the energy
you are consuming.
2
It does not matter which cable
L L
you choose
3. The ,
stop flashing to show that the Smart Plug
is in range and active. If it does not,
please refer to page 18 'Adding Smart
Plugs' in this manual.
Your Display can communicate with up to 6
Smart Plugs. To purchase additional units,
please contact your supplier.
2
, or on the Display will
Ensemble Electricity Monitor, User Manual page 9