Quick Start Guide; Step 1 - Display; Step 2 - Transmitter - Geo Ensemble User Manual

Quick Start Guide

The instructions below show you how to set
up your Ensemble, which has already been
paired to the Transmitter at the factory.

Step 1 - Display

1.
Power the Display using the power
supply provided.
2. Whenever the Display is turned ON,
you will see the 'set clock' screen.
3. Use the left and right buttons on the
front of the Display to adjust the time
and date – then press the Middle (Set)
button when you have finished.
If your system has been supplied with a
Web Pack please set this up now. This will
then simplify the setting up of your Display.
To purchase the webpack please contact
your supplier.

Step 2 - Transmitter

1. Open the unit by pressing the plastic
tab on the back of the Transmitter
and pulling the outer cover away
from the bottom.
2. Remove the battery tab from
the Transmitter.
page 8 Ensemble Electricity Monitor, User Manual
1
1
3. The red light will flash to show that
the batteries are working.
4. After a few seconds, the will
light on the Display to show that it
is communicating with the Transmitter.
2
2
3
3