Geo Ensemble User Manual page 22

Q. What do the Smart Plug columns show me?
A. The Smart Plug columns on the Display light
up from the bottom on the following scale:
1001W-3680W
251W-1000W
26W-250W
5W-25W
Q. How much electricity does the Ensemble
Display use?
A. The Display uses less than 0.35 watt hours
(or approximately €0.07) a month to run (tariff
dependent) - that's less than making a single
slice of toast!
Q. Why does the Display show a different
reading to my electricity bill?
A. The Ensemble system is a good indicator of
your approximate electricity consumption, but
it is only intended as a guide. The Sensor does
not communicate with your meter directly and
will not send your readings to your supplier.
If your supplier asks for a reading, or if you are
checking your bills, always look at the readings
on your meter (NOT your Ensemble Display or
website) as these will continue to be used for
billing purposes.
Q. Where do I find my tariff information?
A. You can find tariff information on your
electricity bill. If not, you will need to contact
you energy supplier.
Q. What target consumption should I set?
A. The target consumption is best set by
working out your daily average from your most
recent electricity bill.
page 22 Ensemble Electricity Monitor, User Manual
Top Segment
Bottom Segment
You could also use this rough guide to what the
average household uses:
• Single person – 5kWh/day
• A Couple – 10kWh/day
• A family of four – 16kWh/day.
Please note that the Ensemble system only
acts as a guide. It does not communicate
directly with your meter and cannot be used to
provide meter readings to your supplier.