Adding Smart Plugs; Replacing A Smart Plug - Geo Ensemble User Manual

Adding Smart Plugs

Up to six Smart Plugs can be paired (talk to)
your Ensemble at any one time. If you buy
additional Smart Plugs you will need to pair
them with your Ensemble.
1. Plug the Smart Plug into a socket. Do not
attach an appliance until pairing is
complete.
2. On your Display press the left and right
buttons simultaneously for a few seconds.
The Display will show 'PAIRMODE'.
3. Select an empty Smart Plug slot using
the Right button to scroll through the
screens. An empty slot is shown by the
number of the Smart Plug flashing while
the Display shows 'PAIR?'
page 18 Ensemble Electricity Monitor, User Manual
4. While this is shown, press and hold the
button on front of the Smart Plug you are
pairing for 10 seconds. The light on the
Smart Plug will then turn amber and the
Display will change to 'PLUGBUG' a few
seconds later.
Tip: If you buy a number of additional Smart
Plugs, plug them in and pair them one at a time.

Replacing a Smart Plug

If you want to replace a Smart Plug, you will
need to unpair the old Smart Plug before
pairing a new one.
1. Put the Display into 'PAIRMODE' by
pressing the left and right buttons
simultaneously for a few seconds.
2. Go to the Smart Plug you wish to replace
using the right button to scroll through
the screens.
3. When you have the Smart Plug you want
to remove, press and hold the centre
button until the Display changes from
'PLUGBUG' (or the name of the Smart
Plug) to 'PAIR?'
4. Add the new Smart Plugs using the
instructions in 'Adding Smart Plugs'.