Table of Contents
Advertisement
Command Control operations
Assigning your vehicle a new ID#
A
s your fleet of Command-equipped Lionel vehicles grows, you'll want to give your vehicle
a more individualized number. Your Speeder can be programmed as either an engine
(ENG) or accessory (ACC). Choose any number between 1 and 98.
Set the vehicle's Command reverse unit switch to PGM (see Figure 1 on page 8). Plug in
the Command Base and place the vehicle on track, then power up. Using your CAB-2/CAB-
1, press ENG or ACC, the vehicle ID# that you select and then press the SET button on the
remote. Set the Command reverse unit switch to RUN. Your vehicle is ready for operations with
its all-new ID#.
We recommend that you choose an easy to remember ID# for your engine. You may choose any
two-digit number that is not used by another engine. Write the number on a small piece of tape
and put this on the underside of the unit to aid in remembering.
Reprogramming the Command reverse unit to restore features
D
ue to the inevitable derailments and static, it is possible that your Command reverse
unit could someday lose its setup program. The symptom of this condition would be
unresponsiveness in Command mode. This can be easily remedied by "reprogramming" your
Command reverse unit using the following steps.
Note!
Your Speeder can be programmed as either an engine (ENG) or accessory (ACC).
STEP 1: Move the Command Reverse Unit switch on your vehicle to the PGM position.
STEP 2: Plug in your Command Base.
STEP 3: Place the vehicle on track, then turn on power to your track.
STEP 4: Press ENG or ACC then input the vehicle's ID#. Press SET.
STEP 5: Turn off power to your track and wait ten seconds.
STEP 6: Remove the vehicle from your track, and move the Command Reverse Unit switch to
the RUN position.
STEP 7: Place the vehicle back on track, then turn power on to the track.
STEP 8: Press ENG or ACC and the ID#, then operate as normal.
6
Advertisement
Table of Contents
