Lionel Railroad Control Tower Owner's Manual
Lionel Railroad Control Tower Owner's Manual

Lionel Railroad Control Tower Owner's Manual

Advertisement

72-4153-250
09/09
Lionel
Lionel
Railroad Control Tower
Railroad Control Tower
Owner's Manual
Owner's Manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Railroad Control Tower and is the answer not in the manual?

Questions and answers

Summary of Contents for Lionel Railroad Control Tower

  • Page 1 72-4153-250 09/09 Lionel Lionel Railroad Control Tower Railroad Control Tower Owner’s Manual Owner’s Manual...
  • Page 2 Operating your Railroad Control Tower with TrainMaster Command Control Replacing the lamps in your Railroad Control Tower Limited Warranty/Lionel Service The following Lionel marks may be used throughout this instruction manual and are protected under law. All rights reserved. Lionel...
  • Page 3 Wiring your Railroad Control Tower he Railroad Control Tower operates best at 12 to 18 volts (AC). You may choose to wire this accessory to the accessory terminals on your transformer, a separate accessory power sup- ply, a Lionel Lockon (available separately, 6-62900), or a FasTrack terminal section (available separately, 6-12016 ).
  • Page 4 Wiring your Railroad Control Tower (continued) Alternately, you may choose to control both the lighting and animation with the switch. Refer to Figure 2 to make the necessary connections. COMMON/GROUND/U POWER/A Figure 2. Wiring for switch control of the animation and lighting Finally, you may choose to leave the light on and activate the animation with an Insulted Track Section (available separately).
  • Page 5 Operating your Railroad Control Tower with TrainMaster Command Control ou may choose to wire your Railroad Control Tower with an SC-2 Switch and Accessory Controller (available separately, 6-22980) or the Accessory Switch Controller (available separately, 6-14182) for operation in the TrainMaster Command Control environment. Refer to these manuals for additional information.
  • Page 6 Control (continued) Accessory Switch Controller wiring and operation Four wires (not included) are needed to connect your Railroad Control Tower to the Accessory Switch Controller (ASC) and a separate accessory transformer. Refer to Figure 5. We recommend using 22-gauge wire.
  • Page 7 To access the lamp, remove the anemometer and the weather vane, then lift off the roof. Unscrew the expired bulb and replace it with Lionel part no. 600-0363-300. Replace the roof to complete the lamp replacement. Refer to Figure 6.
  • Page 8 (or copy) from an Authorized Lionel Retailer*, will at the discretion of Lionel LLC, be repaired or replaced, without charge for parts or labor. In the event the defective product cannot be repaired, and a suitable replacement is not available, Lionel will offer to replace the product with a comparable model (determined by Lionel LLC), if available.

Table of Contents