Introduction; Installation Of Ethernet Driver; Installation For Ms-Dos And Windows 3.1 - Advantech PCM-9576F User Manual

Socket 370 celeron/pentium iiisbc with triple ethernet, cfc and gpio

Table of Contents

5.1 Introduction

The PCM-9576F is equipped with a high performance 32-bit Ethernet

chipset which is fully compliant with IEEE 802.3 100 Mbps CSMA/CD

standards. It is supported by major network operating systems. It is

also both 100Base-T and 10Base-T compatible.

The Ethernet port provides a standard RJ-45 jack. The network boot

feature can be utilized by incorporating the boot ROM image files for

the appropriate network operating system. The boot ROM BIOS files

are combined with system BIOS, which can be enabled/disabled in the

BIOS setup.

Before installing the Ethernet driver, note the procedures below. You

must know which operating system you are using in your PCM-9576F,

and then refer to the corresponding installation flow chart. Then just

follow the steps described in the flow chart. You will quickly and

successfully complete the installation, even if you are not familiar

with instructions for MS-DOS or WINDOWS.

Note 1:

If you want to set up your Ethernet connection under the MS-DOS or

Windows 3.1 environment, you should first check your server system

model. For example, MS-NT, IBM-LAN server, and so on.

Then choose the correct driver to install in your panel PC.

The installation procedures for various servers can be found in the

directory path "LAN/TXT/*" of the drivers and utilities disks, where *

is your server model.

5 8

PCM-9576F User's Manual

The windows illustrations in this chapter are exam-

ples only. You must follow the flow chart instructions

and pay attention to the instructions which then

appear on your screen. Since PCM-9576 supports

3LAN, Users have to install the Ethernet driver 3

times

Table of Contents