Test Run; Operation; Maintenance; Lubrication - Craftex CT167 User Manual

TEST RUN

Now that you have
machine completely, it is time for a test run
to make sure that the machine works
properly and is ready for operation.
All the tools and
assembling the
removed and cleared away during the test
run. Double check and ensure that the wall
mounting bracket is secured properly to the
wall.
WARNING
Before starting the dust collector, make
sure that you have read and understood
the manual and you are familiar with the
functions and safety features on this
machine. Failure to do so may cause
serious personal injury.
Plug the cord to the power outlet and turn
the dust collector ON. See if the dust
collector operates correctly.
During the test run if there is any unusual
noise coming from the machine or the
machine vibrates excessively, shut off the
machine immediately and disconnect the
cord from the power source. Check all the
parts you have assembled once again and
investigate to find out the problem.
If the dust collector operates correctly, turn
the machine OFF and remove the safety
key on the switch.
Once the safety key is removed, turn the
switch ON.
The machine should not run with the safety
key removed.
assembled your
objects used
machine should

OPERATION

CT167 wall
designed to be used with one machine at a
time.
Operating this dust collector is simple and
for easy. Position the machine close to the
be dust collector, making sure that it is not
interfering with each other.
Connect a hose with one end to the dust
collector inlet and the other end to the
machine outlet. Secure both ends using
hose clamps.

MAINTENANCE

During the life of your machine, you will
need to practice some regular maintenance
to keep your saw in peak performance
condition.
Make sure the machine is turned off and
the cord is disconnected from the power
source
removing/replacing any components on
the machine.
Check the dust collector daily for loose
mounting bolts/screws, damaged wires,
worn switch, full collection bag and any
other unsafe condition.

LUBRICATION

The shaper has sealed lubricated bearings
in the motor housing and arbour assembly
and do not require any lubrication.
mount dust collector
WARNING
before servicing
is
and
10