Calibration Error Codes - Kodak PROFESSIONAL LED II 20P Operator's Manual

Diagnostics and Troubleshooting
Error Error Code /Status
Code Message
1 The following file is
locked:_filename_.
2 The following file is
protected:_filename_.
3 The following file was not
found:_filename_.
4 Error:_oserror_occurred
during operation:_operation_
on file:_filename_.
5 The following file is in an
incorrect format:_filename_.
6 The following file already
exists:_filename_.
7 There is not enough space to
create:_filename_.
8 There are too many files to
open _filename_.
9 You do not have permission
to open file _filename_.
10 Error copying print LUT to
DP2 folder (can't open
_filename_.
11 Error creating DP2 LUT
folder
101 No response from
device:_devicename_.
102 Device not
found:_devicename_.
103 The following device is
indicating it is not
ready:_devicename_.
104 The following device is
busy:_devicename_.
105 The following device is not a
TTY port:_devicename_.
5-20

Calibration Error Codes

Possible Cause/Subsystem
The system is trying to access a
file that is currently in use.
The system is trying to access a
file that is protected.
The system was trying to access
a file that it could not find.
An operating system error
occurred.
The file does not conform to the
application specification.
The system is trying to save to a
file that already exists.
The system is trying to save a file
but there is not enough disk
space.
Too many files open.
The file permission is invalid.
Folder doesn't exist or is read-
only.
A folder of the same name may
exist.
The device is not responding to
the system.
The system was trying to access
a device that it could not find.
The device is not ready.
The device is busy.
The port name in the
configuration file does not refer to
a valid serial port.
Possible Solution
Close any other applications that
may be accessing the file.
Change the protections on the file
to grant access to the user.
Verify that the filename on one of
the configuration dialog windows is
correct.
• Rerun the application.
• Reboot the operating system
Verify the file format.
• Delete the existing file.
• Change the filename.
Remove any unnecessary files to
increase free disk space.
Close some files and or
applications.
Rerun the application.
Modify protection on folder.
Change the selected folder name.
Verify that the device is connected
and on-line.
Verify that the device name on one
of the configuration dialog
windows is correct.
Wait several minutes and try the
activity again.
Wait several minutes and try the
activity again.
Change the port name in the
configuration file to a valid serial
port.
September 2000