Pitco SGH50 Full Technical Service Information page 2

THE OIL LEVEL SHOULD NOT FALL BELOW THE MINIMUM INDICATED LEVEL AT ANY TIME.
THE USE OF OLD OIL CAN BE DAGEROUS AS IT WILL HAVE A REDUCED FLASH-POINT
INSTALLATION AND ALL CONNECTIONS MUST BE MADE ACCORDING TO NATIONAL AND
A COUNTRY APPROVED ALL POLE CIRCUIT BREAKER WITH A MINIMUM OPEN CONTACT
GAP OF 3mm MUST BE USED FOR PROPER INSTALLATION.
THE FRYER IS NOT JET STREAM APPROVED. DO NOT CLEAN THE APPLIANCE WITH A
INSTALLATION SHOULD ONLY BE DONE BY A COMPETENT SERVICE TECHNICIAN. THE
MODEL & SERIAL NUMBER, AND ELECTRICAL REQUIREMENTS STAMPED INTO THE DATA
PLATE, LOCATED ON THE INSIDE PANEL OF THE DOOR.
THIS APPLIANCE IS INTENDED FOR PROFESSIONAL USE ONLY, AND AS SUCH, SHOULD
IT IS RECOMMENDED THAT THIS MACHINE BE INSPECTED BY A QUALIFIED TECHNICIAN
THE POWER SUPPLY MUST BE DISCONNECTED SERVICING OR CLEANING THE UNIT.
SHORTENING, WHEN IT IS AT OPERATING TEMPERATURES, IS VERY HOT AND
DANGEROUS! USE EXTREME CAUTION WHEN HANDLING! USE PROPER PROTECTIVE
GEAR SUCH AS INSULATED GLOVES, APRONS, FACE SHIELD, AND SLEEVES WHEN
HANDLING HOT SHORTENING. DO NOT ATTEMP TO MOVE MACHINE THAT HAS HOT OIL IN
IT. ALLOW TO COOLTO ROOM TEMPERATURE OR DRAIN THE OIL INTO A SUITABLE
L22-235 Rev 1 (10/12)
WARNING! FIRE HAZARD
AND BE MORE PRONE TO SURGE BOILING.
WARNING
LOCAL REGULATIONS AND CODES IN FORCE.
WARNING
WATER JET.
BE OPERATED BY FULLY TRAINED PERSONNEL.
ON A YEARLY BASIS.
WARNING
WARNING
CONTAINER BEFORE MOVING THE FRYER.
WARNING
NOTICE
NOTICE
NOTICE