Jeep 2011 Liberty Owner's Manual page 458

1 — Fill Plug
2 — Drain Plug
Adding Fluid
Fluid should be added only to fill hole until fluid begins
to run out of the hole.
MAINTAINING YOUR VEHICLE 457
Draining Fluid
First remove the fill plug (1), then the drain plug (2).
Recommended tightening torque for the drain and fill
plugs is 15–25 ft lbs (20–34 N·m).
CAUTION!
Do not over-tighten the plugs. You could damage
them and cause a leak.
Lubricant Selection
Use only manufacturer's recommended fluid. Refer to
"Fluids, Lubricants, and Genuine Parts" in "Maintaining
Your Vehicle" for further information.
Frequency of Fluid Change
Under normal operating conditions, the fluid installed at
the factory will give satisfactory lubrication for the life of
7