Electronic Roll Mitigation (Erm) - Jeep 2011 Liberty Owner's Manual

340 STARTING AND OPERATING
benefit of the system, you must apply continuous brak-
ing pressure during the stopping sequence, (do not
"pump" the brakes). Do not reduce brake pedal pressure
unless braking is no longer desired. Once the brake pedal
is released, the BAS is deactivated.
WARNING!
The Brake Assist System (BAS) cannot prevent the
natural laws of physics from acting on the vehicle,
nor can it increase the traction afforded by prevailing
road conditions. BAS cannot prevent collisions, in-
cluding those resulting from excessive speed in
turns, driving on very slippery surfaces, or hydro-
planing. The capabilities of a BAS-equipped vehicle
must never be exploited in a reckless or dangerous
manner, which could jeopardize the user's safety or
the safety of others.

Electronic Roll Mitigation (ERM)

This system anticipates the potential for wheel lift by
monitoring the driver's steering wheel input and the
speed of the vehicle. When ERM determines that the rate
of change of the steering wheel angle and vehicle's speed
are sufficient to potentially cause wheel lift, it then
applies the appropriate brake and may also reduce
engine power to lessen the chance that wheel lift will
occur. ERM will only intervene during very severe or
evasive driving maneuvers. ERM can only reduce the
chance of wheel lift occurring during severe or evasive
driving maneuvers. It cannot prevent wheel lift due to
other factors, such as road conditions, leaving the road-
way, or striking objects or other vehicles.
NOTE: ERM is disabled anytime the ESC is in "Full Off"
mode. Refer to Electronic Stability Control (ESC) for a
complete explanation of the available ESC modes.