Jeep 2011 Liberty Owner's Manual page 183

182 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
Place the handheld transmitter 1–3 in (3-8 cm) away
from the HomeLink button you wish to program
while keeping the indicator light in view.
• Simultaneously press and hold both the chosen
HomeLink button and the handheld transmitter but-
ton until the HomeLink indicator changes from a
slow to a rapidly blinking light, then release both the
HomeLink and handheld transmitter buttons.
Watch for the HomeLink indicator to change flash
rates. When it changes, it is programmed. It may take
up to 30 seconds or longer in rare cases. The garage
door may open and close while you train.
NOTE:
• Some gate operators and garage door openers may
require you to replace Step 3 with procedures noted in
the "Gate Operator/Canadian Programming" section.
• After training a HomeLink channel, if the garage
door does not operate with HomeLink and the ga-
rage door opener was manufactured after 1995, the
garage door opener may have a rolling code. If so,
proceed to the heading "Programming A Rolling Code
System."
• Press and hold the just-trained HomeLink button and
observe the indicator light.
If the indicator light stays on constantly, programming
is complete and the garage door (or device) should
activate when the HomeLink button is pressed.
If the indicator light blinks rapidly for two seconds, and
then turns to a constant light, continue with program-
ming for a Rolling Code.
Programming A Rolling Code System
At the garage door opener motor (in the garage), locate
the "Learn" or "Training" button.