Table of Contents
Advertisement
T 15xx Dryers
5.10
Condenser Assembly Removal
Service tip:
To access the condensate pump and/or float switch; the condenser
assembly must be removed from the appliance.
1. Remove the coupler between the fan motor housing and the condenser
assembly.
2. Remove the fan motor; see Section 5.9.
3. Remove the heat exchanger form the condenser; see Section 3.6.
4. Disconnect the electrical connections.
5. Slide the condenser assembly toward the front of the appliance and lift to
remove.
5.11
Condenser Fan Removal
1. Lay the appliance on its back.
2. Remove the four screws securing the bottom cover (see Figure 5-12) and lift
the cover to remove it from the appliance.
Figure 5-12: Bottom Cover Screws
3. Remove the four screws securing the condenser fan to the condenser
assembly (see Figure 5-13).
4. Disconnect the electrical connection.
5. Lift the condenser fan to remove it from the condenser assembly.
33
Technical Information
Advertisement
Table of Contents
