Related Manuals for Miele T1332C
Summary of Contents for Miele T1332C
- Page 1 Operating Instructions Condenser Dryer T 1332 C T 1333 C To prevent accidents and machine damage, read these instructions before Installation or use. M.-Nr. 06 610 680...
-
Page 2: Table Of Contents
1. Turn on the dryer and load the laundry ....... . -
Page 3: Important Safety Instructions
Before this appliance is removed for service or discarded, remove the door to the drying compartment. Do not reach into the dryer if the drum is moving. Do not install or store this appliance where it will be exposed to the weather. -
Page 4: Save These Instructions
IMPORTANT SAFETY INSTRUCTIONS GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction or breakdown, grounding will reduce the risk of electric shock by providing a path of least resistance for electric current. This appliance is equipped with a cord having an equipment grounding conductor and a grounding plug. -
Page 5: Control Panel
"Door" button Opens the door when the program has finished. If the dryer is on, the drum interior will light when the door is opened. If the door is left open, the light will go off after a few minutes to save energy. -
Page 6: Before Loading The Dryer
Dry with normal temperature r Dry with low temperature (select "Gentle" option) s Do not dry in a tumble dryer – Do not overload the drum! Overloading the dryer will result in poor drying results and wrinkling. -
Page 7: Using The Dryer
1. Turn on the dryer and load the laundry ^ Press the "On/Off" button to turn on the dryer. ^ Press the "Door" button to open the door. ^ Load the laundry loosely into the drum. ^ Make sure the lint filters are in place. - Page 8 Using the dryer Program Normal Available drying options: Turbo, Gentle, Anti-crease Extra Dry Multi-layer fabrics, mixed loads of sturdy cottons, e.g. jeans, towels. More Dry Uniform loads of cotton, e.g. sheets, underwear, socks. Normal Knitted cotton fabrics that may shrink, e.g.
-
Page 9: Select A Drying Option (If Needed)
3. Select a drying option (if needed) ^ A drying option can be selected or deselected with each press of the button. Using the dryer OPTIONS Turbo Fast drying for sturdy fabrics with increased temperature and a reduced program length. -
Page 10: Select The Dryness Level
Indicator light: on = buzzer selected off = buzzer not selected Adjusting the buzzer volume: – the dryer must be on – the door closed – a program selected – if the "Buzzer" indicator is lit, press the "Buzzer" button so its indicator light goes out. -
Page 11: Start The Program
Once the program starts, the current cycle of the program will be indicated in the "STATUS" display. Using the dryer 7. At the end of a program The "Anti-crease/End" indicator will light at the end of a program and the buzzer will sound if it was selected. -
Page 12: Canceling Or Changing A Program
^ Press and release the "Start/Stop T" button to start the new program. Adding or removing laundry during a program ^ Turn off the dryer using the "On/Off" button. ^ Press the "Door" button. ^ Open the door. CAUTION - Do not touch the rear... -
Page 13: Child Lock
The "Child lock" indicator will flash. The door can be opened. To activate the child lock 1. Make sure the dryer is turned off and the door is closed. 2. Press and hold the "Anti-crease" and "DRYNESS" buttons at the same time, hold until step 5. -
Page 14: Dryer Care
^ Return the lint filter and close the door. The lint filters (once removed from the dryer) can be rinsed with hot water if necessary. The filters must be dried thoroughly before being returned to the dryer. -
Page 15: Cleaning The Exterior And The Control Panel
Cleaning the exterior and the control panel To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the dryer. -
Page 16: Emptying The Condensed Water Container
1 gallon of water. The container should be emptied weekly. Should the container be full when the tumble dryer is started, or if it becomes full during normal operation: – The "Container" indicator will light. – The buzzer will sound. -
Page 17: Quick Guide
Quick Guide Remove this guide for easy reference Please read all instructions, especially the "Important Safety Instructions", before using the dryer. - Page 18 Quick Guide 1.Turn on the dryer and load the laundry ^ Press the "On/Off" button to turn on the dryer. ^ Press the "Door" button to open the door. ^ Load the laundry into the drum. Make sure that there is enough space in the drum for clothes to tumble freely.
- Page 19 ^ Press the "Start/Stop" button. 7. At the end of a program The "Anti-crease / End" indicator will light. ^ Press "Door" and remove the laundry. ^ Clean the lint filter. ^ Press the "On/Off" button to turn off the dryer.
- Page 20 Quick Guide Program Normal Available drying options Turbo, Gentle, Anti-crease Extra Dry For laundry to be folded and shelved immediately, e.g. jeans, towels. More Dry For uniform loads, e.g. sheets, underwear, socks. Normal For knitted items that may shrink, e.g. jersey material or lightweight cottons.
-
Page 21: Dryer Care
Cleaning the condenser To reduce the risk of electric shock, disconnect the dryer from the power supply by shutting off the power main, tripping the circuit breaker or unplugging the power cord before performing maintenance. ^ Clean the condenser every 6 months. - Page 22 Dryer care Rinsing the condenser ^ Rinse the condenser along the left side with warm water. ^ Rinse the condenser from the front with warm water. ^ Check the condenser for visible soiling. Rinse the condenser until clean. ^ Place the condenser lengthwise on a towel to air dry.
-
Page 23: Changing The Light Bulb
(see illustration). ^ Flip down the bulb cover. ^ Replace the light bulb with a temperature proof bulb, available from Miele. The light bulb must not exceed the maximum wattage listed on the data plate. ^ Flip up the light bulb cover and press it firmly until it clicks into place. -
Page 24: Frequently Asked Questions
What if the drum light does not come on? Possible fault The bulb may be bad or burned out. What if the "Child Lock" indicator flashes after turning the dryer on and a program cannot be started? Possible fault The child lock is activated. - Page 25 What if water has collected around the drum opening? Possible fault This is condensed moisture from the laundry. Frequently asked questions Clean the lint filters. See "Dryer care". Open a window or door to increase airflow. Open a window or door to increase airflow.
-
Page 26: Technical Service
Technical Service In the event of a fault you cannot fix yourself, please contact the Miele Technical Service Department 1-800-999-1360 techserv@mieleusa.com 1-800-565-6435 service@miele.ca When contacting Technical Service, please quote the model and serial number of your appliance. They can be found on the data plate located below the drum opening. -
Page 27: Installation Instructions
Installation Instructions... -
Page 28: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and could void the warranty. Be sure to observe local building codes. Before installation, disconnect the... -
Page 29: Caring For The Environment
Old appliances may contain materials that can be recycled. Please contact your local recycling authority about the possibility of recycling these materials. Ensure that a discarded dryer presents no danger to children. While being stored for disposal remove the door to the drying compartment. -
Page 30: Washer / Dryer Stack
Washer / Dryer Stack The tumble dryer can also be placed on top of a Miele washing machine for a stacked installation. An appropriate stacking kit is required. The stacking kit is available from your Miele dealer or the Miele Technical Service Department. -
Page 31: Electrical Connection
Electrical connection The dryer comes with a 5 ft long, 12/4 AWG cord and a NEMA 14-30 P plug. It should be connected to a 120/208-240 V, 15 A, 60 Hz AC power supply. -
Page 32: Installation
Installation Front view a Power cord with plug b Condensed water container c Control panel d Door e Access panel to condenser f Four height adjustable feet g Optional drain hose: An alternative to using the condensed water container is to drain condensed water into a sink, standpipe or gully. -
Page 33: Installation Tips
This airflow gap must not be blocked by a toekick or thick piled carpets. Do not install the dryer next to a refrigerator. The warm air exhausting from the dryer can affect the thermostat of the refrigerator, causing it to run continuously. -
Page 34: External Water Drain
Maximum delivery head: 4 ft (1.2 m). If the hose is not long enough, an extension hose is available as an optional accessory from the Miele. Pulling out the drain hose Rear dryer top ^ Unclip the drain hose, 1, and pull it off the holder 2. - Page 35 ^ Loop the drain hose up. ^ Use a suitable cable tie to secure the looped hose to the back of the dryer or store the looped hoses behind the dryer. ^ Insert the drain hose to the holder and secure it at the rear dryer top (see holder, 2, "Pulling out the drain...
- Page 36 All rights reserved / 1705 M.-Nr. 06 610 680 / 00...