Onboard Leds; Chassis Intrusion Connector - Asus B85M-E/DASH E-Manual

13. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch. Connect
one end of the chassis intrusion sensor or switch cable to this connector. The chassis
intrusion sensor or switch sends a high-level signal to this connector when a chassis
component is removed or replaced. The signal is then generated as a chassis intrusion
event.
By default, the pin labeled "Chassis Signal" and "Ground" are shorted with a jumper
cap. Remove the jumper caps only when you intend to use the chassis intrusion
detection feature.
B85M-E/DASH Chassis intrusion connector
1.8

Onboard LEDs

1. Standby Power LED
The motherboard comes with a standby power LED that lights up to indicate that the
system is ON, in sleep mode, or in soft-off mode. This is a reminder that you should
shut down the system and unplug the power cable before removing or plugging in any
motherboard component. The illustration below shows the location of the onboard LED.
B85M-E/DASH Standby power LED
1-20
CHASSIS
B85M-E/DASH
B85M-E/DASH
Standby Power
SB_PWR
ON OFF
Powered Off
Chapter 1: Product introduction