System Display; Sensor Batteries - Triumph Speed Triple User Manual

System Display

Warning
Do not attempt to switch between front
and rear tire display modes with the
motorcycle in motion as this may lead to
loss of motorcycle control and an accident.
5
1
6
cfio_14
1. TPMS symbol
2. Tire pressure display
3. Front tire, identified
4. Rear tire, identified
5. Button A
6. Button B
To access the tire pressure display, turn the
ignition to the ON position.
Press and release button 'A' until psi or bAr is
visible in the display screen.
Press and release button 'B' to select the front
or rear tire pressure.
When the tire pressure monitoring system
has been selected, —— psi or bAr will be
visible in the display screen until the
motorcycle is travelling at a speed greater
General Information
than 12 mph (20 km) and the tire pressure
signal is received.
To exit the tire pressure display, press and
release button 'A' to the desired display.

Sensor Batteries

When the battery voltage in a pressure
sensor is low, LO bAt will be displayed and
the TPMS symbol will indicate which wheel
sensor has the low battery voltage. If the
batteries are completely flat, only dashes will
be visible in the display screen, the red TPMS
warning light will be on and the TPMS
symbol will flash continuously. Contact your
authorized Triumph dealer to have the sensor
3
replaced
F
recorded in the spaces provided on page 38.
R
4
1
2
2
chdo_6
1. TPMS symbol
2. Display screen
3. Front tire, identified
4. Rear tire, identified
5. TPMS warning light
With the ignition switch turned to the ON
position, if the TPMS
continuously and the TPMS warning light
remains on there is a fault with the TPMS
and the new serial number
3 5
4
symbol flashes
39