First Access To Ir Dome Network Camera; Setting The Ip Address - Security-Center TV7218 Installation Instructions Manual

First access to IR dome network camera

Setting the IP address

To set the IP address of the camera:
Use a network cable to connect the IR dome network camera to your computer network.
(The simplest way is to connect the IR dome network camera direct to your PC using a cross-link cable.)
If your PC is not yet integrated into a network, you first have to configure it for the network application. Do this by
opening the Properties page for your network.
(This also applies if the camera is connected to the PC via a hub or switch.)
1. Click
2. Enter a fixed IP address and subnet mask
(e.g.: 192.168.0.80 and as subnet mask 255.255.255.0).
, select
.
8
and open the Properties page of the