Page 1
Video surveillance camera Installation Guide TV7014 TV7015 TV7016 TV7017...
Page 2
1. Preface Dear Customer, Thank you for purchasing this ECOLINE digital surveillance camera. You made the right decision in choosing this state-of-the-art technology. This product complies with the current standards of domestic and European regulations. The CE has been proven and all related certifications are available from the manufacturer upon request.
2. Scope of delivery ECOLINE mid-size dome camera (model as described) Installation instructions Fastening screws 3. Features All mid-size dome cameras of the ECOLINE series have the following functions: a) Auto electronic shutter (AES) b) Auto gain control (AGC) c) Backlight compensation (BLC) Additional for colour cameras of this series: d) Auto white balance (AWB) e) Digital signal processing (DSP)
Page 4
This can damage the CCD element and create white dots on the monitor, a sign that CCD pixels are destroyed. Operate the camera only within the specified temperature, humidity and power ranges. Operating the camera outside the prescribed ranges can lead to reduced product life and early malfunction. Greatly exceeding the specified operating ranges can also result in immediate failure of the camera.
5. Installation instructions This camera is designed for indoor use only. If the camera is used outdoors, damage may occur as a result of dampness and temperatures outside the prescribed range. The ECOLINE colour cameras are equipped with an IR cut and cannot be used in combination with IR illumination.
(1) Video output connector (VIDEO OUT) BNC output. This connector is for connecting the camera video signal to the VIDEO IN connector of, for example, the monitor (composite signal: 1Vp-p). (2) Power input 12V DC voltage. Approved for DC voltage are class 2 power supply units only. Ensure the polarity is correct.
Page 9
(10) Automatic / electronic illumination selector (AES) The ECOLINE mid-dome camera is equipped with a DC controlled auto-iris lens (automatic illumination control by the lens). Please do not change the factory setting (OFF). (11) Backlight compensation mode selector (BLC) Depending on the lighting conditions, select one of the following. BLC ON: The centre of the screen is brighter than the edges of the screen.
7. Installation Proceed as follows when installing the camera. Select a suitable place on the ceiling of the room where you would like to mount the camera. Connect the video cable (recommended cable type: RG58) to the BNC video out (1) of the camera and to the following connected video unit. The maximum cable length should not exceed 200 m.
Page 11
If it is necessary, you can manually change the opening of the power- regulated auto-iris aperture using the regulator (12) on the camera module. If there is a video picture visible on the monitor, adjust focus and zoom as required. If there is no video picture on the monitor, please check the following.
Need help?
Do you have a question about the TV7014 and is the answer not in the manual?
Questions and answers