Table of Contents
Advertisement
Application
Weekly schedule
„Sun" ~ „Sat" Selects weekdays for the following operations.
„Snapshots begin at" Sets the time for start of operation.
„Snapshots stop at" Sets the time for end of operation.
Start time and stop time settings should be entered in 24-hour format.
„All the time except for the above schedule" Sets the weekly schedule for all the time except for the times entered
above.
"Snapshot file name prefix" Specify the prefix name for the snapshot file. Please check naming rule of snapshot file
for more detail.
Event reaction
„Delay xx second(s) before detecting the next event" Sets a time delay before restarting, to check the trigger
condition when the current condition is started.
„Send xx pre-event image(s) when event occures" Specify how many pre-event snapshots will be sent if events
happen.
„Trigger condition" Four conditions are available in connection with the digital input, and three windows for motion
detection: You can select more than one condition. Select the condition of the suitable digital input that matches the
properties of the external device. With "Input is high" and "Input is low", the level trigger is selected via the external
voltage input. „Input is rising", „Input is falling" are for flank control.
Three windows are provided for motion detection; you can assign a name to each of them. If motion detection has
not been set, the message "undefined" appears instead of the window title. In this case, click "Motion detection"; a
message appears telling you to go to the motion detection configuration page.
„Trigger action" Four options for three action types are available. You can select more than one condition at a
time. While you are selecting the triggering of an output alarm, both pins are connected by the digital output and
the circuit of the external device is closed. The normal state is open. The commands for uploading snapshots can
be given either by e-mail or via FTP. The names of the snapshots are "vpre.jpg", "vtrg.jpg" and "vpos.jpg". These
stand for snapshots taken before, during and after the event. Optionally, the date and time suffix can be appended.
Confirm the settings of the external e-mail or FTP server in the network configuration.
„Reset output" Select and save this option for resetting the digital output.
Sequencing
„Snapshot interval" The security network camera sends snapshots to the external server at specified intervals using
the method selected below. Don't forget that this process still depends on the conditions set in the weekly schedule.
„Send snapshots by email" This selects the upload method according to the intervals set above. The snapshot with
the name "video.jpg" is attached to the e-mail with the subject name "Periodic Snapshots".
„Send snapshots by email" The snapshots are transmitted to the external FTP server with the file name defined in the
next option. This option can also be used to update pictures stored on the external web server.
„FTP put snapshots with date and time suffix" Adds the date and time to the snapshot so that you can more easily
distinguish between the file names of snapshots either in sequential or event-controlled operation. Example:
"video@20030102030405.jpg" means that the JPEG picture was taken on January 2, 2003 at 03:04:05 (i.e., just
after 3:04 am). If you omit this suffix, the file is updated with the name "video.jpg" on the external FTP server
according to the specified time interval.
38
Advertisement
Table of Contents
