HP Fax 1200 Series Setup Poster

HP Fax 1200 Series Setup Poster
1
Unpack your HP Fax
Remove the print Rest the box on its
a b
cartridges and cords side and pull out your
from the sides of the HP Fax. Remove any
HP Fax. packaging or tape from
the HP Fax.
3
3
Attach paper trays Connect the cable
Slide the top
tray into
place.
Snap the bottom tray into place, and then lower.
6
. .
Connect additional office equipment (optional)
8
Insert black print cartridge
a Raise the top cover up and back. The
print-cartridge carriage moves to the
middle of the access area.
c
Verify that you have
these additional key
components.
power adapter
power cord
phone cord
print cartridges
trays
4
Connect the power cord
3
Connect the power
adapter to the power
cord, and then plug
the power cord into
the power outlet.
This diagram shows a possible configuration for connecting
additional office equipment.
For each piece of office equipment you are connecting to
the HP Fax, remove a plastic tab from the phone/fax
connector.
Remove the black print cartridge (thinner
b Raise both latches on the c
one) from its packaging and, being careful to
print carriage.
touch only the black plastic, gently remove
both the green pull tab and the blue tape
c
covering the nozzles.
CAUTION:
Do not touch
or remove
the gold-
colored
contacts.
For the latest product information, go to:
2
Load paper
a b
5
. .
Connect the phone cord
Use the phone cord to connect your
HP Fax to a telephone wall jack.
1
2
7
.
Turn on your HP Fax
Push the black print cartridge firmly
d
down into the slot on the right. As you
insert the cartridge, make sure the
label is facing you.
www.hp.com
Side 1 of 2
c
a
e Lower the right print-cartridge
latch down onto the top of the
cartridge, and push down until
the latch locks firmly into place.
Turn over to continue.