HP JG221A Installation Manual page 20

Figure 20 Install the front mounting brackets
(1) Chassis front panel
Determine where to install the switch in the rack, and install the cage nuts to the corresponding
3.
positions on the front rack posts.
Supporting the bottom of the switch, move the switch to the appropriate position. Have another person
4.
to install the mounting brackets to the rack posts with the M6 screws. See
Figure 21 Mount the switch to the rack by using front mounting brackets
1
(1) Front rack posts
Rack mounting by using front and rear mounting brackets
To mount the switch to the rack by using front and rear mounting brackets:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded.
1.
Check that the rack is sturdy and well grounded.
2.
1
1
3
(2) Chassis front panel
16
Figure
2
(3) Front mounting bracket
21.