HP 1410 Series Quick Setup Manual

Tool List
Flat-head
screwdriver
The installation tools are not provided with the switch. Prepare them by yourself.
Introduction to installation accessories
Grounding Cage nut and M6 screw
cable (User supplied)
Before installation, wear an ESD-preventive wrist strap, and make sure that the wrist
strap has a good skin contact and is well grounded.
Mounting the switch to a rack
Attach the mounting brackets to the switch
The mounting brackets can be attached to a switch for front or rear mounting. You can
choose a proper position according to the actual requirements.
1
Needle-nose ESD-preventive wrist
pliers
Mounting bracket
and M4 screw
Install cage nuts
Desktop mounting
strap
1
Stick the rubber pads to the appropriate
positions on the switch bottom
Connecting the grounding cable
Rubber
pads
Properly connect the switch grounding cable because it is crucial to the lightning
protection and electromagnetic shield (EMS) of your switch.
1
2
Mount the switch to a rack
1U
2
Connect the OT terminal of the
grounding cable to the switch.
3
Connect the grounding cable to
the grounding strip.
2