Download Print this page

HP JG221A Installation Manual: Installing The Switch Into The 19-inch Rack

A3100 v2 switch series a3100-8 v2 si switch, a3100-16 v2 si switch, a3100-24 v2 si switch, a3100-8 v2 ei switch, a3100-16 v2 ei switch, a3100-24 v2 ei switch, a3100-8-poe v2 ei switch, a3100-16-poe v2 ei switch, a3100-24-poe v2 ei switch.
Hide thumbs

Advertisement

Rubber pads
Each A3100 v2 switch provides four rubber pads, as shown in
workbench, attach the four rubber pads to the switch bottom first.
Figure 19 Rubber pad appearance
(1) Rubber pad

Installing the switch into the 19-inch rack

CAUTION:
Ensure a clearance of 1U (44.45 mm, or 1.75 in) between equipment for heat dissipation.
For a switch with a depth greater than 300 mm (1 1.81 in), the front mounting brackets only secure the
switch rather than bear its weight. To mount this switch to a rack, you need to use front mounting
brackets and other accessories. For example, use front mounting brackets and rear mounting brackets
(for more information, see
mounting brackets and a rack shelf (if there is a rack shelf on the rack, put the switch on the rack shelf,
move the switch to an appropriate position, and fix the switch by using front mounting brackets.).
Rack mounting by using front mounting brackets
NOTE:
The installation procedures for front mounting brackets with different length are similar. The following uses
front mounting brackets supplied with the switch as an example.
To install the switch to the rack by using front mounting brackets:
Wear an ESD-preventive wrist strap and make sure it makes good skin contact and is well grounded,
1.
check that the rack is sturdy and well grounded.
Unpack the screws (packed with the front mounting brackets), and install the front mounting brackets
2.
to the switch with the screws. See
1
"Rack mounting by using front and rear mounting
Figure
20.
15
Figure
19. Before mounting the switch to a
brackets."), or use front

Advertisement

   Related Manuals for HP JG221A

   Related Content for HP JG221A

Comments to this Manuals

Symbols: 0
Latest comments: