Installing the switch
CAUTION:
Keep the tamper-proof seal on a mounting screw on the chassis cover intact, and if you want to open the
chassis, contact the local agent of HP for permission. Otherwise, HP shall not be liable for any
consequence caused thereby.
Figure 16 Hardware installation flow
Start
Install the switch
to a specific
position
Ground the switch
Connect the power cord
Verify the installation
Power on the switch
Operating properly?
End
Installing the switch
Selecting an installation method
The A3100 v2 Switch Series supports multiple installation methods. You can select one as needed.
Table 7 A3100 v2 Switch Series installation methods
Switch model
A3100-24 v2 SI
A3100-24 v2 EI
Troubleshoot
the switch
No
Power off the switch
Yes
Installation methods
Installing the switch into the
19-inch rack (Rack mounting by
using front mounting brackets)
Installation accessories
Front mounting bracket. See callout A in
Figure 17
12
(supplied with the switch).