Picture Id; Network Settings - HP LD4235 User Manual

The buttons below work in PIP mode:
Button
<
>

Picture ID

Picture ID is used to change the settings of a specific display using a single IR receiver for multivision.
Communication is possible between a set with an IR receiver and other sets using audio cables. Each set is
identified by a set ID. If you assign the Picture ID using the remote control, only displays with the same
Picture ID and Set ID can be controlled remotely.
1. Press the red ON button on the remote control
2. If you press the left/right buttons or press the ON button repeatedly, the Picture ID cycles through OFF
and 0 to 4. Assign the ID you want.
If you assign the Set ID to each set with multi-vision, and then assign the Picture ID using the red button
on the remote control, the key command is displayed for the set with the same Set ID and Picture ID. A
set with different Set IDs and Picture IDs cannot be controlled by IR signals.
NOTE: For example, if the Picture ID is assigned to 2, the upper right display (Set ID: 2) can be controlled by
IR signals.
For each set, you can change the settings for the PICTURE, AUDIO, TIME, NETWORK and MY MEDIA menus or
the hot keys on the remote control.
If you press the green OFF button for Picture IDs, the Picture IDs for all sets are turned off. If you then press
any button on the remote control, all sets will start working again.
Picture ID will be disabled while using the MY MEDIA menu.

NETWORK settings

1. Press MENU to access the main menus.
2. Press the Navigation buttons to scroll to NETWORK and press OK.
3. Press the Navigation buttons to scroll to the setting or option you want and press OK.
To return to the previous level, press BACK.
4. When you are finished, press EXIT. When you return to the previous menu, press BACK.
The available option settings are as follows:
Setting
38 Chapter 6 Customizing settings
Photo Movie
o x
o x
x o
x x
x o
x o
x o
Description