Tile Id (Command: D I); Tile H Position (Command: D E); Tile V Position (Command: D F) - HP LD4235 User Manual

Acknowledgement
[z][ ][Set ID][ ][OK/NG][Data1][Data2][Data3][x]
Data1 00: Tile Mode Off
01: Tile Mode On
Data2 00 to 0F: Tile Row
Data3 00 to 0F: Tile Column

39. Tile ID (Command: d i)

To set Tile ID.
Transmission
[d][i][ ][Set ID][ ][Data][Cr]
Data
01 to E1: Tile ID 01 to 225**
FF: Check Tile ID
** Data could not be set over (Tile Column) x (Tile Row).
** It may not be supported depending on the model.
Acknowledgement
[i][ ][Set ID][ ][OK/NG][Data][x]
*NG will be return if data is over (Tile Column) x (Tile Row), except 0xFF.

40. Tile H Position (Command: d e)

To adjust the Tile Horizontal position.
* This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set
to On.
Transmission
[d][e][ ][Set ID][ ][Data][Cr]
Data
00 to 32: -50 (Left) to 0 (Right)
*Left/Right values depend on Tile H size.
** It may not be supported depending on the model.
Acknowledgement
[e][ ][Set ID][ ][OK/NG][Data][x]

41. Tile V Position (Command: d f)

To adjust the Tile Vertical position.
* This function is available only when the Natural option of the Tile Mode is set to Off while the Tile Mode set
to On.
96 Chapter 12 Controlling multiple products