Menvier Security SD1+ Installation Instructions Manual page 6

7. BT. Connections
1. Connect telephone line using one of the methods shown below:
2. Replace the plastic cover over the telephone line connections.
Method 1 - Using the lead supplied
Standard BT telephone plug
Method 2 - Hard wired connections
BT Master Jack (NTE5)
User accessible connections
8. Commissioning and Testing
1. If the SD1+ is not being used in the UK please ensure the options switch is set to the
appropriate settings, see section 9.
2. Hold the blade of a small screwdriver between the "Factory Restart" pins (JP2) and
switch the power back on to the control panel (battery and mains).
3. Remove the screwdriver blade and clip the SD1+ front cover onto the base taking
care not to trap any cables.
4. The SD1+ "beeps" every 30 seconds and the display shows:
5.
To select the programming mode enter the default passcode of 1234
6. The display will show
refer to the "Operating Instructions" for full details.
6
White/Blue
5
4
3
Blue/White
2
1
. The unit is now ready for programming and testing. Please
Cable type 1/0.5mm CW1308
SD1+
White
A
Red
B
SD1+
A
B
.
.