Water Level Pressure Switch - Amana NTW5200T Technical Education

Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.

WATER LEVEL PRESSURE SWITCH

Refer to page 4-2 for the procedure for ac-
cessing the water level pressure switch.
1. Unplug washer or disconnect power.
2. Disconnect the 3-wire connector and the
pressure tube from the pressure switch
inlet.
3. Set the ohmmeter to the R x 1 scale.
NOTE: To activate the pressure switch, blow
into the pressure switch inlet.
4. Touch the ohmmeter test leads to the test
points indicated in the Water Level Switch
Test Table. The switch should change
states when sufficient air pressure is ap-
plied to the pressure switch inlet.
SWITCH
WATER LEVEL
LEFT SIDE OF
PRESSURE
SWITCH
WATER LEVEL SWITCH TEST TABLE
LOCATION STATE
UNDER
PRESSURE
CONSOLE
NO PRESSURE
WARNING
Electrical Shock Hazard
TEST TERMINALS WIRE COLORS
C TO EMPTY
C TO FULL
C TO EMPTY
C TO FULL
5-
Pressure
Switch Inlet
1 2 3
Pin 1 = Full
Pin 2 = C (Common)
Pin 3 = Empty
READING
V TO P OPEN
V TO T 0-10 OHMS
V TO P 0-10 OHMS
V TO T OPEN