Amana NTW5200T Technical Education page 34

8. To remove the fabric select switch:
a) Pull the knob off the switch shaft.
b) Disconnect the wire connectors from
the switch terminals. NOTE: The wire
colors are marked on the switch next
to each terminal.
c) Remove the two hex-head screws
from the switch bracket and remove
the switch from the console.
Fabric Select Switch
Screw
9. To remove the buzzer:
a) Unlatch and disconnect the wire con-
nector from the buzzer terminals (see
the top right photo).
b) Remove the hex-head screw from the
buzzer and remove the buzzer from
the console.
Screw
10. To remove the power supply cord:
4-4
Buzzer
Wire Connector
a) Lift up on the locking tab and discon-
nect the power supply cord connector
from the main harness.
b) Press the locking tab, and pull the
strain relief and power supply cord out
of the rear panel cutout.
Tab
Power Supply
Cord Connector
Screw
Remove Power Supply
Cord & Strain Relief